How we do it Video Sequence – Discovering and fixing a faucet leak

This video takes you thru the steps of how we discover and repair a faucet leak at Essendon Plumbing Providers. In the event you can’t watch the video proper now, learn on beneath for a rundown of how huge Seano sorted out this shopper’s leaking faucet.

“G’Day, huge Seano once more from Essendon Plumbing Providers. I’ve been known as out to a different purchasers premises with reference to a leaking faucet and a excessive water invoice. The shopper’s knowledgeable me that this specific faucet, although it is awfully tight as it may well probably be, remains to be dripping. What I will do right here is I will isolate the water to the principle. I will take out the spindle physique, service and re-washer.

All righty. I have been out to the entrance of the premises. We have remoted the water on the meter. We have disconnected the meter to cease any water backflow or stress rising. What we will do now’s we’re simply going to bleed the faucet. There we go. Simply so I can undo this spindle physique. There we go, take a look at that. A squashed and cut up washer. Once more, it is only a soiled outdated plastic washer. Comes commonplace with a bib faucet and most different tapware that you simply do get.

What we will do, we will test inside the faucet itself. Have a look at that. You’ve got obtained a tiny, tiny little cut up. Like a hairline cut up the place the washer seats. What we will do, we will get a reseating software. Trusty outdated Milwaukee. I do not know of any plumbers that do not run Milwaukee. However take the spindle physique washer out. What we’ll do … You usually do not should nip that up. All you do, a pair brief sharp blasts. A bit squiz. Oh yeah. That face is gorgeous. There’s nada. No extra can we see the hairline cut up.

Okay so these O-rings they do not look actual flash. What we do, get a little bit screwdriver, pop him off. We all know it is a quantity 8.5 O-ring. What we do get him out. Roll this different little bugger on there. Then we wish to get some HydroSeal, faucet lube. Squeeze a little bit bit on there. Work it in. I usually attempt to work it in above the highest O-ring. It simply seems to be good for the shopper. Once more a brand new washer. These HydroSeals. I feel it will be fairly … Once more the longevity of the HydroSeal is much higher than the plastic.

All proper. Good and tight. Flip that off for a minute. What we are going to do, we’ll exit and return the water provide. Come again and check this faucet.

All righty. We simply returned the water provide. Once more simply to check that this has labored, simply transfer the instruments out of the best way, particularly the drill. Nobody likes a moist drill. We’ll simply crack the water on barely. Once more with it going sluggish it will take out little brass filings from refacing. All mounted.

As you’ll be able to see it isn’t only a primary factor of fixing a defective faucet washer or a jumper valve. Once more if you happen to suspect that it’s one thing extra critical or sinister than simply changing a jumper valve please don’t hesitate to contact us at Essendon Plumbing Providers. Once more expertise the distinction of an organization that goes above and past.”

Write a Comment

Your email address will not be published. Required fields are marked *